Buyers Replacement ELECTRIC/HYDRAULIC SPREADER CONTROLLER WITH GROUND SPEED INPUT AND GPS
HVC06 & GPS1
Electric-Hydraulic Spreader &
Electric Liquid Spray Control
Spreader Flow Controller
For hydraulically driven tailgate and V-Box Spreaders using the
HV715E/HV1030E valve or similar proportional valve block. Also has
incorporated Liquid Spray controller for use with Buyers Products
Electrically controlled LS systems or similar units.
Manual and Auto GPS Controlled Auger Switch Function
When "AUTO/MAN" switch (located above "BLAST" button) is
in "MAN" position the controller automatically starts at previous
settings for Auger and Spinner when power is applied. When
"AUTO/MAN" switch is in "AUTO" position displays will flash
"AT" (automatic) until unit acquires a GPS signal. After signal is
established, displays will stop flashing and show "AT" (this process
may take from 30 sec to 1 minute depending upon GPS signal
strength and is normal). The Auger, spinner and Spray flows will
vary based upon speed of vehicle. The selected flow value will be
indicated on the LED panels as 0–10 when in "MAN" mode, not in
"AUTO". To set desired flow for GPS control, change "AUTO/MAN"
switch to "MAN" then set desired flow with adjustment knobs and
then flip "Auto/MAN" switch back to "AUTO" and controller will
output signal based upon speed of vehicle.
When the Auger is being operated at less than full power, the
operator can deliver additional salt by depressing the "BLAST"
button ideal for those "TROUBLE" spots. The output to the Auger
will return to its preset speed after set time (which is adjustable
from 0-30 seconds) has elapsed. The LED display will indicate
"BT" during this function and the blast button will "illuminate" to
indicate that this function has been activated. Please see setting
"BLAST TIME" to change value further down in instructions sheets.
Liquid Spray Control
Control unit has incorporated liquid spray control for electrically
operated systems, such as Buyers Products P/N’s LS1 thru LS8.
When controller is first turned on, the "LOW PRESSURE" light will
illuminate for approx. 2 seconds as well as the "LOW PRESSURE"
buzzer to signal that the system is ready to operate. The light and
buzzer will go off after the 2 seconds (if the tank is not empty or a
nozzle is not plugged). When control is in "MAN" mode, the liquid
spray is controlled by the adjustment knob. To control the flow rate
of the liquid spray, turn adjustment knob under display to desired
flow. If controller is in "AUTO" the liquid spray output is controlled
by GPS and will vary the output with the Auger flow rate based
upon speed of vehicle.
Contact Paris Supply for more information
MADE IN THE U.S.A.
If your item is damaged in shipping or is defective, Paris Supply will take care of getting you a new replacement sent right out to you!!!
"I AM THAT I AM"Exodus 3:14
...God gathers His children in His arms and carries them close to His heart... Isaiah 40:11PST